Skip to main content
True Value
Project

Reassemble Faucet — Reassemble the Shower Faucet

Beginner3 hours

Part of project

How to Replace a Shower Faucet Valve: A Step-by-Step Guide · Step 5 of 5

Helpful?

In this video

Carefully thread the repaired valve cartridge back into the faucet body by hand. Use the spanner to give it a final snug turn, being careful not to over-tighten. Screw the decorative shroud back on, then place the handle onto the splined valve stem. Secure the handle by inserting and tightening the retaining screw. Finally, press the decorative cap firmly back into place on the end of the handle.

Goal: Plumbing Fixture Repair (Faucet)

Used in this video

  • Spanner (brand: Draper, Tool Type: Wrench) — Tightening the valve cartridge.
  • Screwdriver (brand: Unspecified, Tool Type: Screwdriver, Power Source: Manual, Screwdriver_Type: Phillips) — Tightening the handle's retaining screw.
76.2K views36010 minutes
Lowe's Home Improvement

1.3M subscribers

View Channel

FAQs

What are the essential tools I'll need for this shower valve replacement project?

You'll definitely need a screwdriver (a 6-in-1 multi-screwdriver is ideal) and pliers. Depending on how stuck your old cartridge is, a specialized cartridge puller tool might also be necessary. Ensure you have your replacement cartridge on hand before you begin.

What is the most critical safety step I should take before beginning this repair?

The most critical step is to turn off the water supply completely, preferably the main shut-off valve for your home or the specific shut-off valves for the shower. Double-check by running a nearby faucet to confirm the water is off. This prevents flooding and potential water damage.

How difficult is replacing a shower faucet valve for a beginner, and how long should I expect it to take?

This project is rated as 'beginner' difficulty. While it involves several steps, most are straightforward. You should allocate approximately 3 hours, especially if it's your first time or if you encounter a stubborn cartridge.

What should I do if the old shower cartridge is stuck and won't come out easily?

First, ensure all retaining clips or nuts are fully removed. If it's still stuck, you may need a specialized cartridge puller tool, which can be rented or purchased from a hardware store. Applying a penetrating lubricant (like WD-40) and letting it sit might also help loosen it.

Transcript
Hide

So if you swap the seal over like I said and screw the valve back in on both sides make sure everything is tight and fitted back with a spanner, put the valve cap back on, slide the tap end on and lastly insert the washer and screw into the end of the tap. After the screw is nice and tight you're basically going to slide on the end cap on both sides, turn the taps to the on position and now you'll see that the water should be running and

Auto-generated transcript. May contain errors.