Install New Drain Hose Assembly — Disconnect Old Hose from Washing Machine

Beginner2 hours

Part of project

How to Replace a Washing Machine Drain Hose · Step 4 of 7

Helpful?

In this video

Take the new drain hose assembly. First, feed the long outlet end of the hose through its mounting bracket and then route it through the large rectangular opening in the back panel of the washer frame. Align the new mounting bracket with the opening and snap its retaining clips firmly into place on the metal edge. Secure the drain hose to the washer frame using the new plastic retainer clips by pushing the arrowhead fasteners into their corresponding holes. Transfer the original spring clamp from the old hose to the inlet end of the new hose. Push this end of the hose firmly onto the drain pump outlet until it is fully seated against the stop. Finally, use the slip-joint pliers to squeeze the clamp and slide it into position over the connection to secure it tightly.

Goal: Secure the new hose to the washer

Make sure the hose is pushed all the way onto the pump outlet before securing the clamp to ensure a watertight seal.

Used in this video

Slip-joint Pliers (brand: N/A, Tool Type: Pliers) — Positioning the spring clamp on the new hose connection.

170.0K views58610 minutes

Chris Notap

1.1M subscribers

View Channel

FAQs

What type of drain hose should I buy, and does the length matter?

You'll need a corrugated or smooth appliance drain hose, such as the Everbilt 8 ft. Corrugated Washing Machine Discharge Hose. Ensure the new hose is long enough to reach the standpipe without tension or kinks, but not so excessively long that it creates unnecessary loops or becomes obstructed. Always verify the new hose's diameter matches your washing machine's outlet port for a secure connection.

What are the essential safety precautions I need to take before starting this project?

The most critical safety step is to unplug the washing machine from its power source to prevent electric shock. You must also turn off the water supply to the washing machine to avoid accidental flooding. Keep absorbent towels like WYPALL L40 Towels and a bucket, such as the Unger 6 Gal. Heavy-Duty Plastic Bucket, on hand for any residual water.

Is replacing a washing machine drain hose a difficult DIY project, and how long should it typically take?

This project is rated as 'beginner' difficulty, making it accessible for most DIYers. With the necessary tools like pliers and a screwdriver, it typically takes about 1-2 hours to complete from start to finish. This includes preparation, accessing connections, replacing the hose, and final leak testing.

What are common mistakes people make when installing a new drain hose, and how can I avoid them?

A common mistake is not securely fastening the hose to both the washing machine and the standpipe, which can lead to leaks or disconnections. Ensure all clamps are tightened properly and use cable ties, like the Micro Connectors Cable Zip Ties, for extra security. Also, avoid kinking the hose, as this restricts drainage and can cause backflow.

Transcript

Hide

Now before we install the new hose, we're just going to take the outlet end of that, push that back through the mounting bracket. We'll fit the inlet end of it in underneath this left front suspension leg. Slide the outlet hose up through the rectangular opening in the back panel. Then we're going to engage these clips along that metal edge. Make sure it's pulled up tight to that side. Then snap in the retaining clips on the opposite side until they engage. Line up the arrowheads on the new clamp on the bottom. We'll fit that through the opening. Next, we'll reinstall that clamp onto the new hose. We'll set it back far enough. We'll reinstall that holder, inserting those little arrowhead fasteners into the opening on that leg. Position the clamp onto the pump outlet. Make sure that hose is fully inserted to the meats in a little stop.

Auto-generated transcript. May contain errors.